AEROPAK Chrome Paint can provide vivid electroplating effect, which can replace the traditional chroming techniques. It is able to effectively resist UV radiation, enhance the aging-resistance of the decorated goods and prevent eroding. It can be widely applied to metals, wood, glass, ABS and other surfaces. The film finish has excellent hardness, adhesion and flexibility. The film should avoid scrubbing or clashing to prevent the damage of its metal effect.
PREPARATION
For best results, clean surface of grease, wax, rust and dust. Scuff or lightly sand all glossy surfaces removing any unwanted bumps or flaking paint, then dust off. Prime raw timber or metal with Aeropak primer and allow to fully dry.
APPLICATION
IMPORTANT : Shake the can vigorously for one minute before use. Holding the can 30cm from prepared surface, begin by applying one light mist coat, spraying in a continuous motion across the surface working left to right. Pause, allowing the mist coat to set for 30 to 60 seconds, then apply additional coats working at 90° to the first coat. If a thicker finish is required, allow at least one hour between extra coats. When painting over existing paint always check compatibility.
CLEAN UP
Clean any over spray with mineral turps or general-purpose thinners. For better long term storage, turn can upside down and spray until no paint is coming out.
CORRECT DISPOSAL
Spray unneeded product on to newspaper dispose to waste.
Empty can is recyclable.
PRECAUTIONS
Do not use near fire or naked flame.
Do not puncture or incinerate even if empty.
Keep in a cool place out of direct sunlight.
Do not store above 50°C. / 122 F
Never spray at eyes or face.
PROPELLANT: HYDROCARBON
SAFETY WARNINGS
Keep out of reach of children
If swallowed seek medical advice immediately.
Warning - intentional misuse by deliberately inhaling contents
can be harmful or even fatal.