Aeropak Electro Spray Clean is an electric motor and equipment cleaner/degreaser that is created to remove, grease, oil, wax, dirt and contaminants from motors, electronic parts and other electrical /mechanical equipment. Aeropak Electro Spray Clean is quick drying, and does not contain Carbon Tetra Chloride, Silicones, CFC 113, Methyl Chloroform, Trichloroethylene or Tetrachloroethylene.

CAUTIONS

• Read the instructions before use

• Flammable; Deactivate equipment before use.

• Ventilate well after use and before reactivating.

• Protect eyes, skin and do not inhale. (See SDS)

• Test before use, may be damaging to some plastics, e.g. acrylic, ABS and polycarbonate.

• Do not use on sensitive electronics or computers.

IRECTIONS

• Equipment MUST NOT be energized.

• For best results, remove covers and plates to expose interior, and scrape or remove heavy contaminant deposits with a knife or wirebrush.

• Apply liberally and allow to run off.

• Use extension tube for as needed.

• Allow spray to fully evaporate before use.

PRECAUTIONS

Do not puncture, incinerate or store above 5000. Exposure to high temperatures may cause can to burst. Do not place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to observe this warning may result in serious injury from flash fire and/or electrical shock.

CORRECT DISPOSAL

Spray unneeded product on to newspaper dispose to waste. Empty can is recyclable. RECYCLE

SAFETY WARNINGS

Keep out of reach of children

If swallowed seek medical advice immediately.

FIRST AID

If in eyes, hold eyelids apart & flush continuously with running water. Continue flushing for at least 15 minutes or until advised to stop by a doctor. If inhaled, remove from contaminated area, to protect rescuer, use a Type A (Organic vapour) respirator or an Air-line respirator (in poorly ventilated areas). Apply artificial respiration if not breathing. On Skin, If skin or hair contact occurs, remove contaminated clothing and flush skin and hair with running water. Continue flushing with water until advised to stop by a doctor. Ingestion, For advice, contact a doctor (at once).

If swallowed, do not induce vomiting.

PROPELLANT: HYDROCARBON INGREDIENTS

Hexane 50-60% Isopentane 5-10% Propane 10-15% Butane 25-30%